7/27/2023 0 Comments Edge router port forwarding wizard![]() ![]() ![]() I won't go into detail on this because it is really too kludgy. Using Port Forwarding Wizard, it will let you infinitely port forwarding until the destination IP address is achieved. Heaping workaround on workaround: configure port forwarding for Server 192.168.10.100 on EdgeRouter-X, making it reachable on the address 192.168.1.135. Next run a cable from the DSL modem switch ports to eth0 on the Edge router. IP forwarding must be enabled at the firewall for the following IP. Log into the router using the default credentials. This example shows how to use the VPN Setup Wizard to create an IPSec Site to Site. Open a Web Browser and enter in the address bar. 431 Ce the zyxel device is the customer edge router located on the. (The so-called extra hop.) The ISP modem/router will typically try to tell the host to send future traffic directly to EdgeRouter-X by way of an ICMP Redirect message, which the host will typically ignore because ICMP Redirect is considered a security risk. Launch the setup wizard and select Load Balancing accept the defaults, save and reboot. If you are unable to connect to the EdgeRouter, then consider using either the WiFiman Desktop or Ubiquiti Device Discovery Tool. Heres my setup my edgerouter x is running v1.10.1 firmware, my modem is attached at eth0 and my pc that will host the server is plugged into eth1. Run the main Port Forwarding Wizard if you cannot see service you need in the list. This means that all traffic from hosts in 192.168.1.0/24 goes to the ISP modem/router which then forwards it to EdgeRouter-X even though the host could have sent it there directly. Since the network 192.168.1.0/24 is not a single exit network this implies configuring a static route for network 192.168.10.0/24 via 192.168.1.135 on all the hosts in network 192.168.1.0/24, including the ISP modem/router, except of course EdgeRouter-X itself which has a connected route for that network.Įxtra hop routing: again, get rid of NAT on EdgeRouter-X, but configure the static route for network 192.168.10.0/24 via 192.168.1.135 only on the ISP modem/router. The classical solution: get rid of NAT on EdgeRouter-X and configure proper routing. So addresses in the range 192.168.10.0/24 are invisible beyond that router. The fact that devices on network 192.168.10.0/24 can (without configuring a static route on those devices) ping devices on network 192.168.1.0/24 implies that router EdgeRouter-X is actually not acting simply as a router but doing Source NAT, translating the address range 192.168.10.0/24 to its uplink address 192.168.1.135. ![]()
0 Comments
Leave a Reply. |